WTB a cut bezel for M15x antiglare mod.

Discussion in 'Want to Buy Forum' started by MZWiZard, Apr 1, 2017.

Thread Status:
Not open for further replies.
  1. MZWiZard

    MZWiZard Notebook Consultant

    Reputations:
    94
    Messages:
    179
    Likes Received:
    32
    Trophy Points:
    41
    As title says. I'm located in little Denmark, so a europe sale would be preferred.
     
  2. kosti

    kosti Notebook Virtuoso

    Reputations:
    596
    Messages:
    2,163
    Likes Received:
    467
    Trophy Points:
    101
    It's not going to be easy to find one of these, and near impossible to find one already cut out. Ocassionally on e-bay you may find a screen assembly cage without the screen. I have never seen just the bezel for sale on its own. The bezel is held on to the screen cage with double-sided tape.

    Your best bet if you are really serious about this mod is to pry off the bezel from the display assembly cage and get it cut. To remove the bezel, you can use a hair dryer to soften the double-sided tape for easier removal (careful with a heat gun as too much heat will warp the plastic). You can use a plastic tool or a thin guitar pick to start prying it off.

    Once removed, the cutting of the clear screen cover can begin, and to do it right, it should be done with the right tools. Maybe a shop that works with plexi-glass or a shop with a laser cutter can cut it out perfectly.

    Another alternative is to remove the bezel without cutting it and just replace it with a custom bezel, but just cutting the original bezel may be easier.
     
Loading...
Thread Status:
Not open for further replies.

Share This Page