Wondering how to check\flash bios for Packard Bell Dot SE?

Discussion in 'Packard Bell' started by Gambl0r, Oct 26, 2011.

Thread Status:
Not open for further replies.
  1. Gambl0r

    Gambl0r Notebook Enthusiast

    Reputations:
    0
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    5
    I have a Dot SE that won't boot, when I hit the power the power light comes on and the fans start to whir but nothing happens..

    It looks like a bios problem to me, the laptop screen was smashed so I just replaced it and I have tried resetting the RAM and hard drive which made no difference so any suggestions are much appreciated..

    Thanks!
     
    Gambl0r, Oct 26, 2011
    #1
  2. Full-English

    Full-English Notebook Deity

    Reputations:
    1,227
    Messages:
    1,512
    Likes Received:
    8
    Trophy Points:
    56
    Have you checked all of the cables/ribbons, make sure they are all connected correctly, nothing loose etc.

    Also, when replacing the screen, did you have to dismantle the whole unit or just the screen section?
     
    Full-English, Oct 29, 2011
    #2
Thread Status:
Not open for further replies.

Share This Page