Toshiba A135-2286 issues

Discussion in 'Toshiba' started by Bill_A_Nator, Aug 16, 2008.

Thread Status:
Not open for further replies.
  1. Bill_A_Nator

    Bill_A_Nator Newbie

    Reputations:
    0
    Joined:
    Aug 16, 2008
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    First post, yay.

    My Toshiba A135-2286 laptop seems to have issues. When I try to install WinXP, the laptop says it's detecting my system's configuration then it goes to a blank screen and the HDD LED constantly blinks and does nothing. I left it on for about an hour and the LED is still blinking. I was thinking it's the DVD drive because I can still load Fedora pretty well but it can not detect the power supply nor the Ethernet port and it says that the sound card drivers can not load because the sound card can not be detected. I'm really suspecting the motherboard is the problem.

    I bought this May of 2007 and I wish I bought Bestbuy's extended warranty, it would have been worth it. :( Being out of warranty, Toshiba may want to charge me the amount for a new laptop but right now I don't have a job nor do I have the money.

    Any ideas.
     
  2. Bill_A_Nator

    Bill_A_Nator Newbie

    Reputations:
    0
    Joined:
    Aug 16, 2008
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    Is there a known issue with this line of laptops?
     
  3. rlynn411

    rlynn411 Notebook Enthusiast

    Reputations:
    2
    Joined:
    Feb 12, 2008
    Messages:
    39
    Likes Received:
    0
    Trophy Points:
    15
    Not specific to your problem - but the issue running restore CD's can still apply.

    While running a full system recovery from the Recovery Media, the installation may fail -- and display one of the error messages listed below. Possible causes of these error conditions are listed at right. Use this list as a troubleshooting guide -- not as an absolute list of causes, as there may be others.

    "An error has occurred. ERROR :10-FC10-1710" -- may be caused by a faulty hard drive.

    "An error has occurred. ERROR :10-FC12-0241" -- may be caused by a faulty hard drive or defective memory.

    "An error has occurred. ERROR :10-FC12-045D" -- may be caused by a faulty hard drive.

    "An error has occurred. ERROR :10-FC06-0002" -- may be caused by damaged recovery media or faulty hard drive.

    "An error has occurred. ERROR :10-FC12-0970" -- may be caused by defective memory.

    See a lot of this model where on board video fails - you can hear fans but screen remains black.
     
  4. Bill_A_Nator

    Bill_A_Nator Newbie

    Reputations:
    0
    Joined:
    Aug 16, 2008
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    Unfortunately, I threw away the recovery disk and long since formatted the hard drive for Fedora because I was fed up with slow ol' Vista.
     
Loading...
Thread Status:
Not open for further replies.

Share This Page