Simple and very effective cooling "mod" for p775dm2/p775dm3

Discussion in 'Sager and Clevo' started by tanzmeister, Apr 13, 2017.

  1. Papusan

    Papusan JOKEBOOKS = That sucks!! STAHP! Dont buy FILTH...

    Reputations:
    11,245
    Messages:
    18,031
    Likes Received:
    26,581
    Trophy Points:
    931
    Yeah, You need one for Coffee. Another one, but for Coffee.
     
  2. johnbb

    johnbb Notebook Consultant

    Reputations:
    38
    Messages:
    108
    Likes Received:
    24
    Trophy Points:
    31
    Wow! Amazing copper IHS. Do you see any improvement over the stock one?
     
  3. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    7,240
    Messages:
    45,391
    Likes Received:
    11,810
    Trophy Points:
    931
    The stock IHS is nickel plated copper by the way.
     
    Vasudev likes this.
  4. Papusan

    Papusan JOKEBOOKS = That sucks!! STAHP! Dont buy FILTH...

    Reputations:
    11,245
    Messages:
    18,031
    Likes Received:
    26,581
    Trophy Points:
    931
    Same with the Bitspower lid:)
     
    Vasudev likes this.
  5. oSChakal

    oSChakal Notebook Consultant

    Reputations:
    31
    Messages:
    113
    Likes Received:
    47
    Trophy Points:
    41
    Posting here because I'd like to know if it's possible to simply unscrew the heatsink while leaving it in place and sliding the paperclip or do I have to remove it completly?

    Thanks!
     
  6. Kittys

    Kittys Notebook Evangelist

    Reputations:
    155
    Messages:
    442
    Likes Received:
    403
    Trophy Points:
    76
    It is much easier to just remove it and do the mod.
     
  7. Mikki79

    Mikki79 Notebook Guru

    Reputations:
    0
    Messages:
    53
    Likes Received:
    16
    Trophy Points:
    16
    Well I tried this mod and for me it didn't do anything unfortunately, GPU 75c load Before, 75c load after. I guess it was as good as it gets already.

    But I couldn't do it as well either, the heatpipes are welded/soldered whatever so far to one side that it's not really very possible to lay the paper clips from one side to the other, did it more like a C shapre in each side. Maybe that didn't give as much support. Under one of the spring arms it wasn't even possible to put any paperclip

    Tried to put some small wooden sticks under the CPU arms that did nothing either. Well actually it's hotter than after the first time I delided the CPU, but I don't think that's because of this. The CPU has just gotten a bit hotter over the past year for some reason. Well a couple of more years and this laptop will be completely outdated anyway. 6700K :/ kinda outdated already.
     
    Last edited: May 27, 2018 at 5:33 AM
Loading...

Share This Page