RLECViewer: Custom Clevo Fan Control

Discussion in 'Sager and Clevo' started by Zuyang, Jun 17, 2018.

  1. anytimer

    anytimer Notebook Deity

    Reputations:
    196
    Messages:
    1,995
    Likes Received:
    181
    Trophy Points:
    81
    Papusan and Cheddar like this.
  2. John@OBSIDIAN-PC

    John@OBSIDIAN-PC Company Representative

    Reputations:
    727
    Messages:
    2,241
    Likes Received:
    2,771
    Trophy Points:
    181
    sicily428 and Cheddar like this.
  3. Mike Loeven

    Mike Loeven Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    @John@OBSIDIAN-PC
    Any idea if this software can fix the issue on the N870HK1 where the CCC will keep dropping back to automatic a few minutes after setting max fan speed? You had mentioned in some earlier posts about the software sometimes loosing fan control and I am wondering if that's the same exact thing that's causing the problems with CCC

    Also can your software and CCC work together because I use my laptop for work as well as gaming and want to be able to still access power saving mode while overriding the default fan settings ?
     
  4. MiSJAH

    MiSJAH Notebook Deity

    Reputations:
    134
    Messages:
    1,336
    Likes Received:
    1,000
    Trophy Points:
    181
  5. Ed gonn

    Ed gonn Notebook Enthusiast

    Reputations:
    0
    Messages:
    15
    Likes Received:
    0
    Trophy Points:
    5
    Hello everybody,

    I have a Clevo W150HNM model and the fan is always on. I have already changed the thermal paste but it was not sufficient to make the fan works on lower speed. Then I found this tutorial about RLECViewer and OBSIDIAN.

    I need to give you a feedback about both programs.

    ############

    RLECViewer:

    It works only if the battery is plugged on the laptop. The manual configuration is very good and I noticed that the fan starts to get loud and annoying when it is working on 35% of speed. If I unplugged the battery, the laptop turns off after 5 min running the RLECViewer.

    OBSIDIAN:

    I was not able to run this software. After installed, the program does not work and an error message appears telling that is needed to open the program again.

    ############

    Could someone share information about what is the percentage the fan starts to get loud ? In my case was 35%.

    I have open a post to discuss this issue: http://forum.notebookreview.com/threads/clevo-w150-hr-change-the-fan-do-i-need-to-upgrade-it.827976/
     
    Last edited: Mar 16, 2019
  6. bennyg

    bennyg Notebook Virtuoso

    Reputations:
    1,516
    Messages:
    2,331
    Likes Received:
    2,305
    Trophy Points:
    181
    It's model dependent and subjective depending on your ears and whether you use headphones

    There is no harm in playing with the fan/temp table at idle. If you set it too low they might turn off. In which case just put the numbers up again.

    This program is nowhere near as good as Obsidian Fan Control but unfortunately that doesn't work with the old HM and EM series.
     
    Ed gonn likes this.
  7. Ed gonn

    Ed gonn Notebook Enthusiast

    Reputations:
    0
    Messages:
    15
    Likes Received:
    0
    Trophy Points:
    5
    I could not give my opinion about Obsidian because I have a Clevo old series.

    I decided to not use RLECViewer anymore because the laptop turned off several times during the software execution.
     
  8. VovaFenix

    VovaFenix Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    RLECViewer
    Works great! Thank you very much!
    DNS Clevo P170EM i7 3610QM AMD 7970m Drivers Radeon Settings 19.4.1 Windows 10
     
    Last edited: Apr 29, 2019
  9. Zuyang

    Zuyang Newbie

    Reputations:
    0
    Messages:
    5
    Likes Received:
    12
    Trophy Points:
    6
    MiSJAH likes this.
  10. andrewff2

    andrewff2 Notebook Evangelist

    Reputations:
    28
    Messages:
    344
    Likes Received:
    43
    Trophy Points:
    41
    Hey guys!! good day for you all (using my silver shovel in this thread)

    I have a few questions:

    How is RLECViewer holding up now? i've tried v2.4 and is kinda meh.. in comparisson to Obsidian FanControl.

    Right now i have to use RLECViewer because my company security software changes my windows UUID from time to time and my Obsidian FanControl stops working.
    I even exchanged many emails with Obsidian support and everytime they reset my uuid and like 1 week or m
     
Loading...

Share This Page