Official Coffee Lake Refresh Thread/BIOS for ALL Clevo Laptops - RTX CARDS NOW SUPPORTED

Discussion in 'Sager and Clevo' started by DaMafiaGamer, Oct 25, 2018.

  1. jaybee83

    jaybee83 Biotech-Doc

    Reputations:
    4,095
    Messages:
    11,564
    Likes Received:
    9,125
    Trophy Points:
    931
    i was referring to your 4.5 Ghz setting, forgot to mention the clocks but fixed that :)
     
  2. yrekabakery

    yrekabakery Notebook Virtuoso

    Reputations:
    900
    Messages:
    2,658
    Likes Received:
    2,526
    Trophy Points:
    181
    My 8600K is only 6C/6T and it uses 150W in Prime95 1344K AVX at 4.5GHz 1.1V. So I'm not sure how 125W for 4.5GHz is even possible on a 8C/16T 9900K.
     
  3. ole!!!

    ole!!! Notebook Prophet

    Reputations:
    2,386
    Messages:
    5,798
    Likes Received:
    3,716
    Trophy Points:
    431
    need zen2 for that one, it could probably do it with 8 cores with 7nm
     
  4. jaybee83

    jaybee83 Biotech-Doc

    Reputations:
    4,095
    Messages:
    11,564
    Likes Received:
    9,125
    Trophy Points:
    931
    dont ask me haha, im just the messenger here.
     
  5. bennyg

    bennyg Notebook Virtuoso

    Reputations:
    1,552
    Messages:
    2,355
    Likes Received:
    2,350
    Trophy Points:
    181
    Max 116.9W[​IMG]
    TSBench is similar to Prime95 with AVX (no FMA) apparently.
     
    jaybee83 likes this.
  6. yrekabakery

    yrekabakery Notebook Virtuoso

    Reputations:
    900
    Messages:
    2,658
    Likes Received:
    2,526
    Trophy Points:
    181
    Hmmm that's not what I'm seeing?

    TS Bench:
    [​IMG]

    Prime95 1344K AVX/FMA:
    [​IMG]

    BTW @jaybee83 I got my numbers mixed up. 1344K AVX/FMA is actually much lower than 150W as you can see above. 150W was in Small FFTs AVX/FMA (~5W lower with FMA disabled, not much difference). However I doubt a 9900K can do 4.5GHz in 1344K AVX within 125W, given that an 8600K is already close to that.
     
    jaybee83 likes this.
  7. Pagis

    Pagis Notebook Enthusiast

    Reputations:
    0
    Messages:
    18
    Likes Received:
    1
    Trophy Points:
    6
    Did you use programmer or did you manage to do it just with usb?
     
  8. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    8,578
    Messages:
    53,485
    Likes Received:
    15,396
    Trophy Points:
    931
    Probably internal power measurements not being particularly accurate.
     
  9. ScruffyITA

    ScruffyITA Notebook Enthusiast

    Reputations:
    7
    Messages:
    40
    Likes Received:
    3
    Trophy Points:
    16
    hi all again. today im gonna get my new cpu for my p870km. an i5 9600k ( was cheaper then i5 8600k) and is new version.
    ill try to flash the bios in this thread and hope the usb stick works fine without the need to desolder the bios chip. i have also a programmer (sofi sp8-a) that i use for other notebook bios repair, but i hope i dont need to use it on my own pc :D

    ive read that i need also ec flash from previous post to make notebook works with cc 2.0? i already have cc installed, but it say its version 5.0001.1.54
     
  10. DaMafiaGamer

    DaMafiaGamer Notebook Deity

    Reputations:
    777
    Messages:
    1,046
    Likes Received:
    1,170
    Trophy Points:
    181
    I did not TOUCH the ec and everything worked fine. If anything goes wrong with flashing the ec you could brick the board. I wouldn't risk it!

    But, if you know what you are doing then go ahead.

    My mistake: you have a p870km go ahead and flash the ec, you need to so you can install the new control center.
     
    Last edited: Nov 29, 2018
Loading...

Share This Page