*** Official Clevo P75xDM and P77xDM/Sager NP9758-G and NP9778-G "Batman 2.0" Owner's Lounge ***

Discussion in 'Sager/Clevo Reviews & Owners' Lounges' started by ProFX, May 18, 2015.

  1. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    8,381
    Messages:
    52,854
    Likes Received:
    15,204
    Trophy Points:
    931
    You could see if you could source a taller lid after a delid you do reduce the height of the IHS.
     
  2. IllusiveMan

    IllusiveMan Notebook Consultant

    Reputations:
    35
    Messages:
    158
    Likes Received:
    63
    Trophy Points:
    41
    Yes, same here.
    I tried to lower the heatsink itselt for a bit, removed screw holders and this gave a little improvement. I think it is because the heatsink itselt reaches the MB screw holders and heatsink needs a serious adjustment on all 4 corners. I would do that rather than adding extra shims or higher CPU IHS.
     
  3. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    8,381
    Messages:
    52,854
    Likes Received:
    15,204
    Trophy Points:
    931
    Extending the IHS is just adding s thicker copper layer rather than adding a thermal interface so should not be too bad in comparison.
     
  4. Mauserk98

    Mauserk98 Notebook Enthusiast

    Reputations:
    8
    Messages:
    30
    Likes Received:
    29
    Trophy Points:
    26
    Hello everyone i need ur help if any one can give me an modded vBois for my gtx 970m i want to overclock it and see where can go and if i can gain some fpsss thanx
     
  5. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    8,381
    Messages:
    52,854
    Likes Received:
    15,204
    Trophy Points:
    931
    970m vbios mod in Google hits for me ;)
     
  6. Buzzbugs

    Buzzbugs Notebook Enthusiast

    Reputations:
    0
    Messages:
    17
    Likes Received:
    9
    Trophy Points:
    6
    Feeling very disappointed with my P750DMG. It's only 3 years old and It's now had a major GFX card failure. It's been in for repairs with Metabox for over a month, and it turns out to be a $600 repair.
     
  7. Papusan

    Papusan JOKEBOOK's Sucks! Dont waste your $$$ on FILTHY

    Reputations:
    24,361
    Messages:
    24,365
    Likes Received:
    42,643
    Trophy Points:
    931
    980m is a rotten card. It lack needed VRMs (People have soldered on the 3 missing MOSFET chips to help it to survive). I hope Metabox will do the same for your card. Or you risk run into the same once again. I mean all other 980m cards outside Clevo brand have exactly the same flaws. Put the blame on Nvidia.
     
  8. Buzzbugs

    Buzzbugs Notebook Enthusiast

    Reputations:
    0
    Messages:
    17
    Likes Received:
    9
    Trophy Points:
    6
    As far as I know all they've done is replace the card with a new one.
     
  9. Papusan

    Papusan JOKEBOOK's Sucks! Dont waste your $$$ on FILTHY

    Reputations:
    24,361
    Messages:
    24,365
    Likes Received:
    42,643
    Trophy Points:
    931
    I would ask if they could solder missing VRM from your broken card (If they still works) or new one. But I'm not sure if they will do that.
     
    Arrrrbol likes this.
  10. Buzzbugs

    Buzzbugs Notebook Enthusiast

    Reputations:
    0
    Messages:
    17
    Likes Received:
    9
    Trophy Points:
    6
    I tried asking them that, but they are unable to do it. I don't think it's something I'll risk doing myself, either, as I've never soldered anything before.

    My friend has a 9 year old gaming laptop that's never skipped a beat.

    Hopefully I get at least 3 more years..
     
    Papusan likes this.
Loading...

Share This Page