HP Omen X Owner's Lounge

Discussion in 'HP' started by Graedon, Dec 8, 2017.

  1. GreatD

    GreatD Notebook Consultant

    Reputations:
    64
    Messages:
    279
    Likes Received:
    103
    Trophy Points:
    56
    I would only use non-conductive TIM. It's to risky on a expensive device. I personally use Thermal Grizzly Kryonaut paste on my HP Omen 17 w200na (pavilion lookalike laptop) and my temps have reduced 10-15 c degrees.
     
  2. goto35

    goto35 Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    hp omen x (17 inch gtx1080) set up raid 0- but speeds are the same! restart issue as well


    i installed 2- 2tb nvme drives.



    put raid in bios (only one setting)



    then installed windows



    then used the intel raid software to create raid 0. then reinstalled windows 10 on the raid. my speeds are exact the same 3200 (was the same with one drive)



    also having a issue when i restart it just goes blank. doesnr actually start. i have to hold down power and hard off the turn on.





    this is for restart every time.



    what am i doing wrong? what setting do i need to change.



    on raid it created a 4tb just fine but speeds did not increase at all

    REPLY
     
  3. isko

    isko Notebook Enthusiast

    Reputations:
    0
    Messages:
    17
    Likes Received:
    0
    Trophy Points:
    5
    Hi to all,

    Im using Omen X ap020nr laptop and I have new updates in Omen Command Center v9.0.4.0.

    But the problem is I dont have "Performance Mode" at all. I can't choose Defeat or Performance mod, and no fan speed.

    How to fix this? :(
     
Loading...

Share This Page