How do i properly clean Thermal Grizzly Condunaut?

Discussion in 'Hardware Components and Aftermarket Upgrades' started by Al_Jourgensen, Feb 9, 2018.

  1. Papusan

    Papusan JOKEBOOKS = That sucks! Dont wast your $$ on FILTH

    Reputations:
    13,474
    Messages:
    19,036
    Likes Received:
    29,265
    Trophy Points:
    931
    Then post pictures when first application is done (disassemble and check spread - before final application).

    upload_2018-2-13_2-39-59.png
     
    Al_Jourgensen likes this.
  2. TheReciever

    TheReciever D! For Dragon!

    Reputations:
    243
    Messages:
    1,594
    Likes Received:
    834
    Trophy Points:
    131
    That just means you have poor contact at the very least
     
    Al_Jourgensen likes this.
  3. jclausius

    jclausius Notebook Virtuoso

    Reputations:
    1,102
    Messages:
    2,575
    Likes Received:
    1,094
    Trophy Points:
    181
    In regards to your CPU, perhaps you could get some ideas from this video -

    But instead of lapping the CPU, you'll be lapping the heat sink.
     
    Last edited: Feb 13, 2018
    Al_Jourgensen likes this.
  4. hmscott

    hmscott Notebook Nobel Laureate

    Reputations:
    4,800
    Messages:
    16,649
    Likes Received:
    20,489
    Trophy Points:
    931
    @GENOCID - this kind of proactive manipulation of the heatsink/heatplate is what I was talking about, fiddling / wiggling to get better contact patch across CPU when loose, and pressing down on the cooling plate / assembly before screwing it down. Give an assist to the screws pulling it down.

    Good work Al :)
     
    Al_Jourgensen likes this.
  5. Al_Jourgensen

    Al_Jourgensen Notebook Consultant

    Reputations:
    12
    Messages:
    161
    Likes Received:
    32
    Trophy Points:
    41
    Thank you all for your replys, I'm enlightened now, I only have one problem, where do I buy those squares? Or something similar? The sand paper is fine to get, but the block I can't find it; as I told you, block here means brick and I'm googling to try to find one but no luck, gonna try harder and as soon I have something I'll feedback right away.

    Thank you very much for your help once again

    Update: i found this https://m.ebay.co.uk/itm/COPPER-Sheet-Plate-8-Different-Thicknesses-23-Popular-Sizes-/302204943332 I don't know if this are the blocks.
    What thickness should they have?
     
    Last edited: Feb 13, 2018
    hmscott likes this.
  6. Papusan

    Papusan JOKEBOOKS = That sucks! Dont wast your $$ on FILTH

    Reputations:
    13,474
    Messages:
    19,036
    Likes Received:
    29,265
    Trophy Points:
    931
    You can use what you have. Small and flat enough and fits in you hand. Or search after similar like this www.performance-pcs.com-premium-heatsink-lapping-kit
     
    Ashtrix, hmscott and Al_Jourgensen like this.
  7. Al_Jourgensen

    Al_Jourgensen Notebook Consultant

    Reputations:
    12
    Messages:
    161
    Likes Received:
    32
    Trophy Points:
    41
    hmscott and Papusan like this.
Loading...

Share This Page