Clevo P650HP6-G (ish) overheating problem

Discussion in 'Sager and Clevo' started by Enver Kaan Eris, Feb 6, 2018.

  1. MahmoudDewy

    MahmoudDewy Gaming Laptops Master Race!

    Reputations:
    391
    Messages:
    1,526
    Likes Received:
    614
    Trophy Points:
    131
  2. senso

    senso Notebook Evangelist

    Reputations:
    82
    Messages:
    313
    Likes Received:
    180
    Trophy Points:
    56
    Kryonaut is pretty thick!

    Thicker than Artic-MX4..

    I have been using Artic MX-4 for 4 years already, got Kryonaut when it got out, and Kryonaut is thicker than the MX-4, both work wonderfully in laptops, Kryonaut wins over, buts its like a huge difference, good heatsink contact will make more impact than crazy thermal pastes.

    Just last weekend I lapped my GT72 CPU heatsink, re-applyed Kryonaut and it stays at 62-64ºC playing BF1 on High settings without even using the fan boost button(but I'm running a custom fan curve on EC via Svet EC editor, at 62-64ºC the fans are around 50% speed, and they make almost no noise compared to the full speed fan boost that sounds like a jet engine).
     
  3. MahmoudDewy

    MahmoudDewy Gaming Laptops Master Race!

    Reputations:
    391
    Messages:
    1,526
    Likes Received:
    614
    Trophy Points:
    131
    MSI heatsinks are far superior to some of the old Sager laptops like mine. Maybe it is different for newer machines.
     
  4. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    7,240
    Messages:
    45,391
    Likes Received:
    11,810
    Trophy Points:
    931
    Well heatsink design has been improving a lot in the last few years.
     
  5. aIex

    aIex Notebook Consultant

    Reputations:
    12
    Messages:
    134
    Likes Received:
    18
    Trophy Points:
    31
    It's actually P670, not P650. P650, a 15-incher has far better ventilation under the case. Mine also gets around 96 and 71*C on CPU and GPU respectively while using Prime95 and FurMark altogether. However, I have had my motherboard replaced and I think my temps actually worsen after the replacement too. What method do you use when applying thermal compound?
     
  6. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    7,240
    Messages:
    45,391
    Likes Received:
    11,810
    Trophy Points:
    931
    X for square dies, thin line for rectangular dies for thermal paste.
     
Loading...

Share This Page