Advice on adding a Dual Touch digitizer to a Touch only CF19.

Discussion in 'Panasonic' started by Geraout, Aug 19, 2018.

Thread Status:
Not open for further replies.
  1. toughasnails

    toughasnails Toughbook Moderator Moderator

    Reputations:
    7,107
    Messages:
    6,188
    Likes Received:
    2,253
    Trophy Points:
    331
    Couple things.....
    1. By just take the digitizer screen there is always a chance of breaking . It's stuck on the front very good.

    2. Changing/rerunning the wire is another pain so be very careful not to pinch or break them.

    This is the reason why Shawn says swap the whole lid....less chances of things going wrong. This is how I did mine years.

    And yes I learned the hard way. I have broke screens before changing them .
     
  2. Geraout

    Geraout Notebook Consultant

    Reputations:
    9
    Messages:
    244
    Likes Received:
    56
    Trophy Points:
    41
    Thanks for the advice all.

    Not as straightforward as it sounded.

    I think I will leave as it is!
     
  3. ohlip

    ohlip Toughbook Modder

    Reputations:
    1,110
    Messages:
    2,358
    Likes Received:
    107
    Trophy Points:
    81
    Yes! You can. It was only held by double sided tape on both side of LCD but you need to take out the LCD harness, LED inverter and TS digit. board too and pull outward the the thin LCD pcb board. Btw you need also to transfer the harness of dual touch. I can say a lot of work.

    As adviced above better to replace the top half.

    ohlip
     
    Shawn likes this.
Loading...
Thread Status:
Not open for further replies.

Share This Page