About detaching the dvd drive from E4300

Discussion in 'Dell Latitude, Vostro, and Precision' started by kerrylau, Nov 27, 2008.

Thread Status:
Not open for further replies.
  1. kerrylau

    kerrylau Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    How to detach the dvd drive from E4300? Can it be detached just like the HDD drive easily? Is there an air bay module (or a cover) for the hole of the dvd drive? thanks
     
  2. John Ratsey

    John Ratsey Moderately inquisitive Super Moderator

    Reputations:
    6,736
    Messages:
    27,906
    Likes Received:
    1,203
    Trophy Points:
    581
    See the service manual for the removal instructions.

    I don't think there's a cover for the bay. Dell have had problems supplying the correst weight saver module for the E6400 but, as and when they sort this out, the module may also fit the E4300 is the burner is the same 9.5mm thickness.

    John
     
  3. PvD

    PvD Notebook Consultant

    Reputations:
    16
    Messages:
    156
    Likes Received:
    0
    Trophy Points:
    30
    1 Close the display and turn the computer upside-down
    2 Remove the memory cover.
    3 Remove the M2.5 x 5-mm screw securing the optical drive to the system board. The screw is located in the center of the lower-left edge of the memory module compartment.
    4 Using a scribe, push on the tab that held the screw to slide the optical drive from its slot on the side of the computer.

    [​IMG]
     
Loading...
Thread Status:
Not open for further replies.

Share This Page