So I try to place a copper shim 0,2mm (LM / copper 0,2 / LM) Temps are better of 5/6c but i read in a post that a member placed a 0,5mm copper.
I know... but after repast full LM with 0,2 copper shim, temps are good. 82c now. 99/100c before.
Do you think i try with 0,5mm copper?
Actualy i have kryonnaut /copper 0,2mm / kryonnaut
Yep 100c on 3dmark
Room @ 30c
So I apply à 0,2mm copper with Kryonnaut and temp are bad...
I apply graphit pads only on cpu & gpu. I’m not crasy [emoji6]
Perfect! More difficult to apply but better result
I have Alohacool pads is it good ?
Do you have a picture of all pads on heatsink with the good thick of every pads?
I says many pads are 1,5mm but I think many of them could be...
I would prefer graphite pad than LM for tests.
It s very strange. I have good pression on gpu. I gain 5c with screws exchange. But cpu is over 92c in cpu test of 3dmarks. LM + graphite pad.
So i replace the original screws by M2 3mm. And its perfect with good pression.
Did you know the reference of the heatsink screws in razer Blade 15,3 2018???
I would like to change them.
Thank you for tour answer. I will try 2 graphite pads 0,2 +0,2 tais afternoon.
Do you have any problem of heatsink pressure on cpu die or not ?
The pads touch just a little bit the backplate. With very ligh pressure. Just a simply contact to transfer thermal.
No pressure on ssd connector.
I just ran 5 tests consecutive with ATTO. Default options : 56c Max
Which parameters for the test ?
I can. With Crystal disk mark i ran 3 tests i took screenshot at the end.
Separate names with a comma.