Probably a really long shot, but the bottom PCMCIA slot on my CF-18 MK2 had never worked since I bought it. I'm trying to ascertain whether both...
Lies Snowy... I'm sooooo offended.. you should owe me a coffee next time we meet up :P
My Libretto 70CT doesn't appear to be posting, all I'm getting out of it is a quick blink of the hard drive light as thats powered up. No light...
I've seen units fail to boot when components on its I2C bus failed to initialize and didn't want to play nice. A good(ish) indication would be...
I purchased mine last year for £35 in "Toughbook Good" condition. Few light scratches and dings, but other than that its fine. Its on the CF-P2...
If it is the switch, Power + Reset + Rec, Pull battery cover of quick. Screen should flash something about reading binfs and the SD thingy. The...
Actually, would you mind pressing Power, Reset, and UP Volume, and taking a picture of the screen that the CF-P2 displays? The pull the battery,...
The .bin not found message would be the CF-P2 bootloader trying to load firmware files from the SD card and not finding any. You probably need a...
Chances are, because there was no main power source actively applied, the backup battery held ram data up for a while, and after that started to...
I'd be interested in getting this to work on my CF-M34 MkIII Did try Sadlmkr's instructions however they required HAL which I can't install on my...
Odisee: Its a Ni-Mh 2.4v 15Ah Rechargeable battery pack. Varta part 2/V15H Service manual quotes part number "N4HHECB0001". [IMG]
not necessarily, as i sorta said (maybe not very clearly), it could be something on the dock connector, or an SD card that doesn't want to play...
panasonic backup pops up after the "Welcome to Windows Mobile" and calibration screens. If you're not getting past there, it could be some form of...
@tkteun Hmm, it has been a while since I played around deeply with my CF-P2, but taking a look at the block diagram here, whilst its not rock...
I asked Panasonic if they'd kindly slip a BSP my way a while ago when I wanted to get Windows CE6 running on my CF-P2. Unfortunately Panasonic...
Thought so. My cf-p2 gets woken up when I enabled roaming on the orange/t-mobile partnership. As a hackish hack solution, go into...
Hmm. Is the phone roaming by any chance? I know mine wakes up when it roams off of its home network. It could also be another wakeup event...
Might be a wake up event set incorrectly in the registry, or even a faulty button on the device. Enable all wakeup events under...
IIRC, a long hold of the power button just turns the backlight off, hence it staying on. Give the power button a quick press, then wait for it to...
...which is why I don't get it that the same SIM card using the internal GPRS causes far less drain that the HSDPA stick. Its honestly stumped me.
Separate names with a comma.
