Clevo BIOS Thread

[Blacky]

Why don't you contact your reseller?

[anmatheextreme]

Probably memory issue, your sys may not be able to see and read RAM. BIOS may also be the cause of your problem. Does your system pass through POST?, because, if not, you can't perform any update or test the system. Maybe a Dead-on-Arrivall, i don't know. My suggestion is to call your reseller as Blacky has already mentioned.

[aukjan]

I have a xxodd w870cu, which is a clevo w870cu, and I tried to update both ec\kbc and bios to version .10

The ec\kbc flash succeeded, but with the bios flash it tells me that it worked, but the bios remains at .01 I have also tried to update the bios to .12 but with the same (no) result.

Any ideas?

[Blacky]

I've update initial post. What is the latest BIOS for the D900F and M980 cause I think those are the only ones which I haven't updated ?

@ aukjan: I have no idea.

[Sylver123]

I've update initial post. What is the latest BIOS for the D900F and M980 cause I think those are the only ones which I haven't updated ?

@ aukjan: I have no idea.

I`m sure the latest BIOS for the D900F is 1.00.07c which was released on April, unless there's now a new one we don`t know about yet.

[korculanac]

the last BIOS for M66xSR is 1.00.06 which was released on 2008/4/18, so it's a little bit old but that is the final BIOS from Clevo. To update to this version, you have to update EC Firmware first to 1.00.04 if it had not been done before. Please check your versions by entering System setup when booting ( normally by pressing F2). And if you need any of them, just post your email here.



Hi PKhetan, i need the BIOS for M66xSR is 1.00.06, Can you email it to me. Is it difficult to update? My EC Firmware already has the 1.00.04 installed!

Thanks for your help!!

[theriko]

Here is the BIOS .06 for M66xSR and here is the .04 EC for same.

[korculanac]

Thanks so much. To upgrade this bios, i just follow the Zfactors guide to flash your bios using a USB stick?

[Blacky]

Yes, just read the first post.

[aukjan]

I have a xxodd w870cu, which is a clevo w870cu, and I tried to update both ec\kbc and bios to version .10
The ec\kbc flash succeeded, but with the bios flash it tells me that it worked, but the bios remains at .01 I have also tried to update the bios to .12 but with the same (no) result.

Well, it worked now... Disabling the running of 'autoexec.bat' on startup from the usb drive fixed it Flashing went as planned!