ok the one on the left says LAN-MAIN(BLACK) the smaller section of antenna below says EVDO-AUX(BROWN) the antennas on the right side of screen says WWAN(GRAY) and the smaller section says LAN-AUX(WHITE)
Ok you have the two antenna's now you have to follow the black and white wire back to the bottom of the unit. As I said the gray wire is for the wwan antenna and you should not have that on your wifi card.
yeah thats what i was thinking. the white wire should go to aux on wifi card and im missing the short gray jumper that goes to main and i just leave the gray wwan hooked up where it was originally. right?
yeah the tech manual shows the white aux wire coming from the aux port on the card and disappearing under the board and it does go up to the antennas and then it shows the short grey jumper coming from the main port on the cand going ovev a short disntance to a port next to a black wire. the distance from the main port of card to the other end of connection is only about 3/4" apart. what is this part called where the other end connects?
i keep getting an error message also when i try to do the wireless setup wizard. the error msg says. depending on the wireless software running on this computer,the wireless setup wizard might not work. the zero configuration is enabled. anyone know about this? i have it hooked up and it wont recognize my network