Quantcast Buying a Router - Advice Needed

+ Reply to Thread
Results 1 to 10 of 10
  1. #1
    Notebook Deity
    Join Date
    Jul 2007
    Location
    Winnipeg, MB
    Posts
    1,562
    Rep Power
    21

    Default Buying a Router - Advice Needed

    Looking to pick up a router to use as a wireless repeater since the wireless connection in the basement is spotty. It's not possible to run Cat5 to connect the two either, I need to have this router be able to wireless connect to the router upstairs and be able to wirelessly connect to this one (no wires anywhere except upstairs).

    1) Is this even possible?
    2) I was looking at these 3 routers since they seem to do well in terms of speed and functionality. Any other recommendations?

    D-LINK DIR-655 Xtreme N Gigabit Router 802.11G/B/N Wireless Router Triple Antenna QoS - D-Link - DIR-655

    Buffalo Airstation High Power N450 Gigabit Wireless N Router - Buffalo - WZR-HP-G450H

    Linksys Expert E3200 Dual Band Wireless N Router 802.11B/G/N 4PORT GbE USB Port - Linksys - E3200-CA

  2. #2
    Notebook Deity
    Join Date
    Jul 2009
    Location
    Midwest
    Posts
    1,295
    Rep Power
    15

    Default Re: Buying a Router - Advice Needed

    From personal experience, I wouldn't touch that D-Link. That particular model has a long history, and most of it is not good.

    The others should be fine, but I would also recommend looking at Netgear.

    Sony VGN-SZ750N - Win7 x64, 4gigs ram, Intel 40GB SSD, Intel 5300 Win7 X64 upgrade guide
    Fujitsu Stylistic ST5020D tablet - Ubuntu, 1.25gigs ram, Wacom Penabled for graphics work.

  3. #3
    Notebook Evangelist
    Join Date
    Apr 2009
    Posts
    493
    Rep Power
    12

    Default Re: Buying a Router - Advice Needed

    I have done the same research on a wireless router and after a reseller tried to sell me a Cisco 4200 v1 as Cisco 4200 v2 I was lucky enough to find the ASUS RT-N66U:
    Amazon.com: ASUS RT-N66U Dual-Band Wireless-N900 Gigabit Router: Computers & Accessories
    when I was on the verge to buy a 2+ years old router running open source DD-WRT or tomato USB, e.g. Asus RT-N16U
    http://www.amazon.com/RT-N16-Wireles...7716500&sr=8-1

    because all the reviews were telling that no off-the-shelves wireless router is stable unless you unlock it with open source solutions which are mostly available for the Broadcom based router cpus.

    Please do not blindly pay attention to the lower rated comments on Amazon.com for Asus RT-N66U unless you read them carefully. They were triggered mostly by the problems with the initial buggy firmware which have been successfully fixed. After those fixes even with the Asus firmware people report a very stable wireless router even with the stock firmware.

    The reason why RT-N56U, also a very good router, could not run open source firmware such as DD-WRT or tomatoUSB, was due to its processor which was not Broadcom as opposed to the old RT-N16U and the newest RT-N66U.

    RT-N66U was by far the best in March 2012, maybe some newly released routers could finally matched it - I don't know, but the positives were:
    1) dual band N900 router
    2) Large 256MB ram
    3) Broadcom cpu which made him a very good candidate to replace RT-N16U as one of the best open source routers after a firmware flash with tomatoUSB or DD-WRT. It looks like Netgear WNDR4500 has the same chipset/cpu.

    Read here a comparison to the RT-N16U whose already ram and cache were considered among the best in its class:
    http://tomatousb.org/forum/t-423607
    ASUS RT-N66U Dark Knight Dual-Band Wireless-N900 Gigabit Router Reviewed - SmallNetBuilder

  4. #4
    Sacred Blame
    Join Date
    May 2010
    Location
    Terca Lumireis
    Posts
    7,075
    Rep Power
    40

    Default Re: Buying a Router - Advice Needed

    The problem with the RT-N66U is that Asus isn't that good at writing formware and not everyone wants third party firmware. The E4200v1 is actually as good or better than the v2 at pretty much everything except NAS like functions, the v2 has a NAS CPU made by Marvell and Linksys lacks experience writing firmware for those.

    450Mbps on 2.4GHz is ridiculous unless you live somewhere where there are no other 2.4GHz networks around, most manufacturers tout it as a feature, but there is no way you're gonna be able to have 450mbps on 2.4GHz in an even remotely crowded wireless environment. I would scratch that as a deal breaker.

    Of the routers that offer 450Mbps on 5GHz, the E4200v1 remains my main recommendation for stock firmware. If you want third party firmware, i can see the RT-N66U being a good investment and i'd take the Asus over any D-Link crap. If you are on a limited budget, the WNDR3700 v2 and the Linksys E3000 (can be had for rather cheap now) are good choices.
    Current: Precision M6700¦3720qm¦2x240GB SSD + 256GB mSATA¦32GB DDR3 1600MHz¦Firepro M6000
    Previous: Asus G73Jh-A2¦920xm¦160GB G3 + 7K750¦Chastity vBios¦ICD7 + 0.5mm pads¦Intel 6300
    Old: Asus N50Vn-B1B P8600 2.4GHz¦4GB DDR2 800MHz¦500GB 7200RPM¦9650M GT 1GB

  5. #5
    Eat.My.Shorts
    Join Date
    May 2008
    Location
    ®oaming NBR
    Posts
    2,079
    Rep Power
    22

    Default Re: Buying a Router - Advice Needed

    Did the Wireless Repeater thing in the past with the old faithful Linksys WRT54G and the WRT54G2 routers. Both flashed with dd-wrt fw.

    Once you do your research first to see if the routers you're interested in is supported by dd-wrt or has 'Repeater' mode OTB then it's just a matter of configuring.

    If they don't support it OTB;

    1) First, see if the routers are supported by the fw.

    after looking at the min. required fw ver. under the 'Notes' section of the supported devices Table.

    2) Flash it!

    Router Database | www.dd-wrt.com

    Search for your Router model in the Database, download the fw and flash.

    After flashing

    3) Configure it.

    Repeater Bridge - DD-WRT Wiki

    Universal Wireless Repeater - DD-WRT Wiki

    After reading those links you should be on your way.

    Now, I only mentioned dd-wrt because that's the only fw I've personally used in the past.



    HP ML110G6 Server:
    Intel Xeon X3440 @ 2.53GHz | 16GB DDR3 Mem. | (1)500GB HDD (3)250GB HDDs in Software RAID5 | Windows Server 2012 Standard


    Envy 14 Beats:
    Intel Core i5 560M @ 2.67GHz (32nm) | 8GB DDR3 Mem. | Crucial M4 120GB SSD | *BrightView* 1366x768 LCD | Windows 8 Enterprise x64

  6. #6
    Notebook Deity
    Join Date
    Jul 2007
    Location
    Winnipeg, MB
    Posts
    1,562
    Rep Power
    21

    Default Re: Buying a Router - Advice Needed

    I decided to pick up the Asus RT-N66U. It's more expensive than what I was looking for but it's the #1 router and should be something that can last me years and enable full-house wireless capabilities without the hassle of multiple routers.

  7. #7
    Notebook Consultant
    Join Date
    Apr 2012
    Posts
    170
    Rep Power
    3

    Default Re: Buying a Router - Advice Needed

    I would go powerline to be honest. I'm going to be doing the same thing but reversed (no reception in my bedroom).

    With a wireless repeater you get diminishing returns on signal strenght and bandwidth. With powerline you don't. You don't need any wires as long as you have a power outlet. They have wireless powerline units as well.

    I've read and heard wonderful things about powerline networking.

    Also they are a hell of a lot cheaper.
    Sager NP9170 | i7-3610QM | AMD ATI 7970M With 2GB DDR5 | 8GB Dual Channel DDR3 1600MHz | 120GB Intel 520 Series SSD | 500GB 7200rpm HDD | 8X DVD±R/RW/4X +DL | Intel Centrino Ultimate-N 6300


  8. #8
    Eat.My.Shorts
    Join Date
    May 2008
    Location
    ®oaming NBR
    Posts
    2,079
    Rep Power
    22

    Default Re: Buying a Router - Advice Needed

    ^ QFT.

    Yea, Any clients connected to the Repeater their bandwidth is halved.

    I plan to do this again in the future, I might take a look at Powerline when that time comes.



    HP ML110G6 Server:
    Intel Xeon X3440 @ 2.53GHz | 16GB DDR3 Mem. | (1)500GB HDD (3)250GB HDDs in Software RAID5 | Windows Server 2012 Standard


    Envy 14 Beats:
    Intel Core i5 560M @ 2.67GHz (32nm) | 8GB DDR3 Mem. | Crucial M4 120GB SSD | *BrightView* 1366x768 LCD | Windows 8 Enterprise x64

  9. #9
    Notebook Virtuoso
    Join Date
    Mar 2006
    Posts
    3,436
    Rep Power
    31

    Default Re: Buying a Router - Advice Needed

    I've used Powerline adapters in the past. When you can't get a radio or limited service these work quite well. Once you have it to your location setup a second router as a AP if you want wireless. Then you will have a small switch too for a desktop computer if needed.
    Apple MacBook Pro 15", dual boot
    Netgear FVS-338 8-port VPN router,
    Dlink DGS-1216T GigE switch,
    Netgear WNDR3700v2 used as AP
    3 Snap4500 NAS units

  10. #10
    de_dust2
    Join Date
    Nov 2011
    Location
    Europe
    Posts
    3,764
    Rep Power
    20

    Default Re: Buying a Router - Advice Needed

    Quote Originally Posted by blue68f100 View Post
    I've used Powerline adapters in the past. When you can't get a radio or limited service these work quite well. Once you have it to your location setup a second router as a AP if you want wireless. Then you will have a small switch too for a desktop computer if needed.
    Had a powerline adapter at home until my brother decided to accidentally fall on it..... got a retarded Zyxel now oh well
    powerline ftw

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
All times are GMT -4. The time now is 06:19 AM.
Powered by vBulletin® Version 4.2.0
Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.
SEO by vBSEO 3.6.0