RTM875t-606( Info gathering and OCing)

[charlyd]

hi tanjo-15,

you wrote: Hi all.

I tried this mod on my aspire 8920g and it worked a treat.
Just grounded pin 4 of rtm875t-606 to ground.
Then i ran set fsbset and slowly ramped the cpu to 2.6 gig and is still very stable.
My notebook has the t8300 in it.

hope this helps.

where about is the RTM875t-606 postion on the mainboard and what exactly did you do, you connected pin 4 to GND(ground) and did you disconnect anything for pin 4 ? resistor or something else? i want to do this mod also,i have an x9000 (Q174 cpu) and then let s have a look what i can do..

so info or picture wanted Tanjo-15 of you mod.

thanks in advance

[moral hazard]

charlyd why do you need to overclock the PLL when you can just increase your multi:
How to Unlock the Core 2 Extreme Multiplier in Windows

[charlyd]

charlyd why do you need to overclock the PLL when you can just increase your multi:
How to Unlock the Core 2 Extreme Multiplier in Windows

hi yes you are right i saw the article earlier but the unlock was not working but yes of course i had an other cpu then... ;-) yes yes it is working.... thanks very very much, and what about the guy in this topic who grounded pin 4??? is that not working or... i am lucky with this CPU x9000 Q174

[imask]

If your system FAILS..............STOP, you need to try and setup the PIN17/18 Pin Config (I'll add a table for this later if we have anyone that needs it, post a reply to this topic.)

is this topic still live?
need help, my fails.


cpus T5250 1,5Ghz and backup T7500 would try oc too.

[naton]

I have an Eisystem laptop and the clock gen is the RTM875t-606. I took the laptop apart and checked it.
I went to Diagnosis->PLL Diagnosis (Clock generator drop down menu)->Click FSB. The result is shown below.

Do i have to do the PLL mod? Does the mod work with the intel GL40? and does it add support for FSB1066?

Edit:
When I select RTM875T-606 in SetSFB 2.3.166.131 (trial version), I get a "PLL ID Error"!

[MZWiZard]

For what its worth, I have finally had some succes with that RTM875T-606 on my Extensa 5630G with currently a T7250 cpu (2.0GHz, 2.2GHz IDA).

RTM875T 250MHz overclocking tool alters the FSB to 250MHz. No version of setfsb i have tried have worked before other than freezes.

(Nvm all the other I wrote as it is not relevant for this thread)

[Nosfer@tu]

Picture in post 0 is gone

[antyfr]

i all and thanks i have an hp hdx x16 with rtm875n-606 (square version)
i have grounded pin 11 and i have this now
nando4 validate i have the tme enable
but when i do this my system freeze
i think i have to do another pinmod on pin 17 18??but i dont know how.
thanks for your help

[conduit34]

I also have rtm875n-606. My board is for an HP G56 intel based.
Is there another msg board for this?

[conduit34]

I have rtm875n-606.
Can you please refer me to the post that shows how exactly you ground pin 11.