M15x FSB Overclocking (not only 920XM!)

[craigscott0]

this is what i get if its the FSB to 140

[Mr Pras]

A couple of thoughts:

Try setting the number to 492

DON'T use the diagnose panel, just use the NORMAL BASIC ONE

[T120ted]

492 bumps it down to 489 by itself.

[craigscott0]

I shouldnt be able to do this
Attachment 52851

[Mandrake]

Even at 140 it stays the same.

Your registers aren't populated. Are you using a paid version?

this is what i get if its the FSB to 140

Make sure your power scheme is set to "High Performance"

[craigscott0]

Your registers aren't populated. Are you using a paid version?



Make sure your power scheme is set to "High Performance"

It is. if i change it to slp or mmt it will automaticly jump to 1626 mhz but i can up the fsb to 202 mhz and no effect when the system should die

[T120ted]

yeah I paid for it but maybe it didn't register right but everytime I open it it doesn't ask me for a code.

[Mr Pras]

Hey, can you give us a link where to download these Benchmark tools you used?! I'm about to give it a try, I'd like to have some base numbers to compare!

http://www.lavalys.com/sites/default...ltimate550.zip

yeah I paid for it but maybe it didn't register right but everytime I open it it doesn't ask me for a code.

If it has the Set FSB option then it's registered..

It is. if i change it to slp or mmt it will automaticly jump to 1626 mhz but i can up the fsb to 202 mhz and no effect when the system should die

Try turning off your system and do a COLD reboot. (meaning let it shut down fully and be off for a few seconds before starting it up again).

Load up windows, open setfsb, asusn61jq, get, set number to 492/760, press set fsb.

That's all I did. Didn't change anything else in the program. It's defaulted to QPC and I didn't touch that!

[craigscott0]

Try turning off your system and do a COLD reboot. (meaning let it shut down fully and be off for a few seconds before starting it up again).

Load up windows, open setfsb, asusn61jq, get, set number to 492/760, press set fsb.

That's all I did. Didn't change anything else in the program. It's defaulted to QPC and I didn't touch that!

Na nothing, just says fsb is now 149.5 but when i put 492 it jumps down to 489.

Do you think that the MOBO's could be slightly revised? when did you purchase yours? mine is only 3 weeks old.

[Mandrake]

I have one that is a month old and another that is 3 months old both with the 920 and it works.